Photoduino Solenoid Valve Interface 1.0
Photoduino’s firmware version 0.10 was released to include the ability to control a solenoid valve and automatically generate drops with Photoduino.
Solenoid valves are typically powered through 12VDC and have a high current consumption, so we need this new circuit to be connected to Photoduino’s DEVICE port so it allows the connection to a solenoid valve and a 12VDC power supply.
The control of the valve is performed by a Mosfet IRL520 logic transistor and the circuit also includes a 1N4004 diode to prevent the reverse current that is accumulated in the coil.
The board is designed in a single sided PCB so it is quite easy to make at home, but it is also available for purchase as a kit which includes a solenoid valve, a 60 ml syringe and a 12VDC battery holder.
The 12V needed to feed the solenoid valve can be supplied by the 8xAA (R6) battery holder included in the kit. You can also use a 12VDC with at least 500 mA current (not included).
|1||PCB Solenoid valve interface 1.0||eaglecad files
order at oshpark.com
|1||12v Solenoid Valve||jameco|
|1||10 Kohms resistor||mouser|
|2||2 pins terminal block||mouser|
|1||8xAA battery socket||mouser|
|1||RCA pcb female jack||sparkfun|
|1||RCA male-to-male cable||farnell|
|1||50 ml syringe luer catheter without needle||totclinic|
|1||Doble wire 2×0,50mm|
|1||Microtube 4mm x 0,25cm|
Check the Building Instructions
- Download the Eaglecad files of the circuit
Some other pictures